Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Arlington?
Spring replacement in Arlington typically costs $180 to $340 for one spring. Most doors have two springs that wear out together, so a matched pair usually lands around $360 to $680. Those are estimated ranges for a typical job. The written estimate we give you on site sets the final price.
If your door came down hard or won’t lift at all, stop pulling on it. Call (855) 340-9110. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free, and same-day service is often possible.
We’re Garage Door Repair Arlington Pros, a focused garage door specialist working across Arlington and the surrounding Northern Virginia neighborhoods. Springs are one of the most hazardous parts on any door, and they’re a core specialty here, not a job we hand off. Our technicians have up to 12 years of experience, and we’re factory-familiar with eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor.
Quick answer at a glance
- One spring: typically $180 to $340
- Matched pair (most common): roughly double that, about $360 to $680
- What sets the price: spring type, door weight, how many springs your door uses, and whether cables or bearings need attention while we’re in there
- Free estimate: the written estimate sets the final price
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers shake out for a spring job in Arlington. Every figure below is a typical estimated range, not a fixed quote. Your written estimate is what counts.
| Line item | Typical estimated range | Notes |
|---|---|---|
| One torsion spring replaced | $180 – $340 | Standard residential door, single spring |
| Matched pair of torsion springs | ~$360 – $680 | Most two-car doors use a pair; replaced together |
| Extension spring (single) | $180 – $340 | Older or lighter doors with side-mounted springs |
| Cable repair (if cables are frayed) | $130 – $250 | Often caught during a spring job |
| Roller replacement | $110 – $220 | Worn rollers add noise and strain |
| Track realignment | $120 – $240 | If the door jumped or shifted |
| Opener repair (if the opener was strained) | $120 – $320 | Only when the opener is affected |
| General garage door repair | $150 – $600 | For combined issues beyond springs alone |
What drives the price up or down: A single spring on a light one-car door sits at the low end. A pair of heavy-duty springs on an insulated two-car door, plus a cable that let go when the spring snapped, sits higher. High-cycle springs that last longer cost more up front but last longer between replacements. And if your door has been straining against a broken spring for a while, the opener and rollers may need attention too, which adds to the bill. We lay all of this out before we touch anything, so there are no surprises.
What Affects Spring Replacement Pricing in Arlington
Arlington has its own mix of housing that shapes what a spring job looks like. The county runs from older brick colonials in neighborhoods like Lyon Village and Cherrydale to newer townhomes and condos around Ballston and Clarendon, plus the single-family streets of Arlington Forest and Dominion Hills. That range of door types and ages means no two spring jobs are quite the same.
- Number of springs: One spring or two. Most two-car doors use a pair, and a pair is usually replaced together because the second spring is close behind the first. That’s why a pair costs about twice a single.
- Spring type and cycle life: Standard-cycle springs cost less; high-cycle springs (rated for more open-and-close cycles) cost more but stretch the time between replacements. We match the spring to your door’s weight and your daily use.
- Door weight and material: A solid wood or insulated steel door is heavier than a basic panel door and needs a stronger spring, which nudges the price up.
- Condition of cables, drums, and bearings: A snapped spring often takes a cable with it. Frayed cables, worn drums, or dry bearings get flagged and can be handled during the same visit, adding to the line items but saving you a second call.
- Access and ceiling height: Tight garages, low ceilings, or unusual track setups take more time and care. Arlington’s older homes sometimes have low-clearance garages that change how the torsion system is set up.
- Brand and door system: We work with Clopay, Amarr, Wayne Dalton, and Raynor doors among others, so we source the right spring for your specific door rather than forcing a generic part.
If you want the fuller picture on spring work itself, our spring replacement page walks through what the job involves from start to finish.
Why Spring Repair Isn’t a DIY Job
Torsion springs store an enormous amount of energy. When one lets go, it can do so with a violent snap, and the tools and winding bars used to tension a new spring can injure an untrained hand badly. This is one of the most hazardous jobs in the trade. We don’t hand out step-by-step instructions for it, and we’d gently steer you away from the videos that do. Replacing a spring safely means matching the wire gauge and length to your door’s exact weight and balancing the door afterward so the opener isn’t fighting a mis-tuned system. That’s the kind of work we do in-house, every day.
If your door is stuck, resist the urge to force it open or closed, and keep hands and fingers clear of the hinge and spring areas. Call us and we’ll take it from there.
How to Save on Spring Replacement
Springs aren’t a place to shop purely on the lowest number, because a cheap spring that fails early costs more in the end. That said, a few habits keep your total down:
- Replace both springs at once. If one has broken and the pair is the same age, the second is likely near the end of its life. Doing both in one visit is cheaper than two separate calls.
- Catch cables and rollers early. When we’re already on site for springs, worn cables or rollers can be handled in the same trip, so you’re not paying for a second visit later.
- Keep the door balanced. A door that’s been straining against a tired spring wears out the opener and hardware faster. Addressing it promptly protects the rest of the system.
- Lubricate moving parts. A little routine care on hinges, rollers, and tracks reduces strain and helps springs last their full cycle life.
- Get a free estimate first. We’ll tell you exactly what needs replacing and what can wait. Call (855) 340-9110 and we’ll give you a written estimate at no charge.
Same-Day Repair and What to Do When a Spring Breaks
A broken spring usually announces itself: a loud bang from the garage, a door that won’t lift, or a door that rises a few inches and stops. We treat spring failures as urgent because a door stuck open or stuck closed can’t wait. That’s why emergency garage door service is a named offering here, not an answering service that promises a callback.
We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. If you call outside those dispatch hours, we book you into the next opening, Sunday through Friday, 7am to 7pm.
Until a technician arrives, leave the door down if you can and keep it clear of traffic. Don’t try to lift it manually, and don’t run the opener against a broken spring; that only strains the motor and adds to the repair.
When you call, we ask a few quick questions: the door’s size, roughly how old it is, and what it’s doing. That helps us come prepared with the right springs and any parts we may need, so the job is more likely to be finished in a single visit.
Repair or Replace? When Springs Are Just the Start
Sometimes a spring job is the whole story. Other times it’s a signal that the door is near the end of its life. Here’s how we think about it. If the panels are sound, the tracks are straight, and the hardware is in decent shape, replacing springs is almost always the right call, and it’s far cheaper than a new door. If the door is badly dented, rusted through, or the panels are separating, putting new springs on a failing door may not make sense. In that case a full replacement, typically $700 to $2,200 for a new door installation depending on size, material, and insulation, could be the better long-term spend. We’ll give you an honest read either way, and one call covers repair, opener, spring, or full replacement with no referrals or runaround.
For everyday fixes short of a full replacement, our Garage Door Repair Arlington Pros team handles the full range of door problems across the area.
Springs, Openers, and the Brands We Know
A failed spring often drags the opener down with it, since a strained opener works harder to lift a door that’s suddenly heavy. Because opener repair here spans LiftMaster, Chamberlain, and Genie, the three brands found in the majority of homes, we diagnose opener problems that show up alongside a spring failure without a second trip. We’re certified to work on eight of the most widely installed door and opener brands in the country, so parts are sourced correctly the first time. For new doors, we install Clopay, Amarr, Wayne Dalton, and Raynor, spanning entry-level to premium lines.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Arlington?
Spring replacement in Arlington typically costs $180 to $340 for one spring, or about $360 to $680 for a matched pair. The written estimate sets the final price. Call (855) 340-9110 for a free estimate.
Is it cheaper to repair or replace a garage door spring?
Repairing the spring is almost always cheaper than replacing the whole door, and it’s the right move when the panels and hardware are in good shape. A full new door installation runs $700 to $2,200, so a $180 to $340 spring repair is a fraction of that. Call us for an honest assessment: (855) 340-9110.
Why does a pair of springs cost about twice as much as one?
A pair costs about double because you’re replacing two springs instead of one. Most doors use two springs, and they’re usually the same age, so replacing both together saves you a second service call down the road. Expect roughly $360 to $680 for a pair. Call (855) 340-9110 for an exact estimate.
Do you offer same-day spring repair in Arlington?
Yes, same-day service is often possible. We answer 24/7 and dispatch from 7am to 7pm, Sunday through Friday. Call (855) 340-9110 and we’ll book the earliest opening.
Can I get service on a Saturday?
We’re closed Saturday. We’re open Sunday through Friday, 7am to 7pm. If your spring fails on a Saturday, call and we’ll book you into the next opening, Sunday through Friday. Call (855) 340-9110.
What else might I need to pay for during a spring job?
Sometimes cables, rollers, or tracks need attention at the same time, which adds line items like $130 to $250 for a cable or $110 to $220 for rollers. We flag anything we find before doing the work. Call (855) 340-9110 for a free estimate that lays it all out.
Get a Free Spring Replacement Estimate in Arlington
Broken springs are dangerous, and a door that won’t operate isn’t something to sit on. We work on every major door and opener brand, handle springs in-house, and cover everything from a single broken spring to a full new installation. Whether you need spring replacement, opener repair, or a whole new door, one call covers it. Call (855) 340-9110 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Arlington market as of 2026. Garage Door Repair Arlington Pros offers free estimates – call (855) 340-9110.
Written by the team at Garage Door Repair Arlington Pros.
What Our Customers Say
"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Kevin Mercer"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Dev Shah"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Dale Doyle